|
|
HUB
SIZING for LOCKING ASSEMBLY CONNECTIONS
B-LOC Locking Assemblies connect components and transmit
loads through a mechanical interference fit generated by high
contact pressure exerted on both shaft and hub. This pressure
will result in tensile (expansion) stresses in the hub, meaning
that consideration must be given to the amount of hub material
required. If the mounted component is insufficiently sized,
the applied tensile stresses will cause plastic deformation
and the result will be damage to the component and a failure
of the connection.
|
B-LOC HUB OD CALCULATION TOOL (for
a detailed explanation of these calculations, please refer
to Page 24 of our catalog.)
To
calculate a minimum required hub OD for a component to be
mounted using a B-LOC Locking Assembly, please enter
the information requested below and then click "CALCULATE".
|
|
 |
|
